If Your Blackberry Curve Screen Gets Cracked, Your Expensive smartphone Becomes Little More Than A Paperweight. Once An lcd Screen Gets Cracked, It Cannot Physically Be Repaired, But Rim Designed The Curve 8310 So That You Can Open Up The Phone And Replace The Screen. If You Have Never Opened Up A Cell Phone Before, Set Aside About half An Hour To Complete The Process, But If You Are Comfortable Working On Phones It May Take You Just A Few Minutes.


Requirements:
● T4 screwdriver
● T6 screwdriver
● Pry stick
● Replacement LCD
● Replacement front housing


►step 1 Turn The Curve Over And Press Down On The Small metal Button Near The Bottom Of The Device. While The Button Is Down, Push Up On The Battery Cover And Remove It.

►step 2 Pull Up On The Top Of The Battery Until It Is At A 30-degree Angle, Then Pull It Away From The Device. Remove Your sim Card And Your Memory Card, If They Are Installed.

►step 3 Use Your T4 screwdriver To Remove The Two screws Located On The Top Of The Phone. One Of The Two May Be Hidden Under A Piece Of Paper.

►step 4 Place Your Pry Stick Under The Silver Plastic Piece Located Directly Below The Battery latch Button. Push Down On This Piece Until It Pops Off.

►step 5 Turn The Curve 8310 Over And Place Your Pry Stick Between The Front Cover And One Of The Side Pieces. Twist The Pry Stick Until You Hear The Front Cover Pop Off. Repeat This Process On The Other Side Of The Device, Then Pull The Front Cover Away From The Curve.

►step 6 Remove The Four screws Around The Keypad Using Your t6 Screwdriver. Pull Up On The Black Plastic Keyboard Cover To Remove It And The Keypad.

►step 7 Pull The Two side Pieces Away From The Curve. Then Lift The Control Board Out Of The Back Housing.

►step 8 Lift Off The Metal Shield That Is Surrounding The Lcd. You May Have To Push The shield Up A Little Since It Will Be Hooked Onto A Piece Of The Control Board Above The Lcd.

►step 9 Place Your Pry Stick Under The Lcd And Gently Twist It Until The Lcd Comes Free From The Control Board. Disconnect The Lcd Connector.

►step 10 Reverse These Steps To Assemble The Device Using Your Replacement Lcd And Front Cover, Instead Of The Original Pieces.